Skip to content
Project: Radar

Code Upload

Upload Radar from your browser and run your first scan.

Remove all projectiles before uploading

The servos move when the board restarts. Keep the mechanism clear and the launcher unloaded through the first scan.

1. Upload in KriyaStation

Connect the NodeMCU with a USB data cable and follow the upload steps in KriyaStation.

Open in KriyaStation

2. Connect to the launcher

Wi-Fi network
Launcher Radar
Password
12345678

Join this Wi-Fi network even if your device reports no internet. Open http://192.168.4.1 in your browser and wait for LIVE. Anyone on this network can control the launcher.

3. Run your first scan

  1. Aim at a flat target 30–100 cm away. Compare the distance with a ruler.
  2. Hold an arrow briefly. The launcher should stop when you release it.
  3. Tap AUTO SCAN and keep the target still.

What success looks like

After the sweep, the launcher returns to 90° and the button reads AUTO SCAN again. Echoes appear as dots. Gaps mean the sensor found no valid echo at those angles.

See an example scan
Troubleshooting
KriyaStation can’t find the board?
Check that your USB cable carries data, then reconnect in KriyaStation.
The controller won’t open or says OFFLINE?
Check that your device is still on Launcher Radar Wi-Fi and that the address starts with http://.
No distance reading?
Check the sensor wiring and aim it at a flat target directly ahead.